Luxor Commander

Luxor Commander is a powerful tool built for miners compatible with Windows, Linux and MacOS operating systems. Commander allows you to effortlessly scan your network for Bitcoin ASICs, monitor machines, update settings and install LuxOS directly to NAND to miners with stock firmware.

You can download Luxor Commander from our Download Center (opens in a new tab).

Getting Started

Scanning Network

Luxor Commander allows you to scan your network to discover mining machines. Follow these steps to perform a network scan:

1. Open Luxor Commander.
2. Click the Configure Network button. This will open a model where you can input a single miner IP, an IP range or multiple IP ranges.
3. To start the scan, click the Scan Network button.

Acceptable IP formats include:

• Single IP: 192.168.1.1
• IP Range: 192.168.1.1-192.168.2.255
• IP Range: 192.168.1.1/24

After the scan finishes you will see the list of miners that were discovered on your network. If you enable Auto-Sync Commander will pull additional information from the miners and update the list.

Installing LuxOS

Luxor Commander allows you to install LuxOS directly to NAND on miners with stock firmware.

1. Select the machines you want to install.
2. Click the Install LuxOS button. A new screen will pop-up.
3. Click Begin, enter your License Key and click Activate License. If you have already activated Luxor Commander, you can proceed.
4. Click Start Install to initialize the installation process.

After a few minutes you should see the install finish and your ASICs will boot into LuxOS. You're all done.

If you have any questions, please reach out to us on here (opens in a new tab).