voltageset

Description

Sets the current voltage of the system.

Note: This command will always fails if the curtailment mode is sleep. See the curtail command for details.

Command

$ echo '{"command": "voltageset", "parameter":"yJN2nlj1,1,8.9"}' | nc $MINER_IP 4028 | jq

Note: In previous luxminer versions, this command required a board_id parameter, to apply the voltage change to a single board. This is not allowed anymore, and you should omit this parameter on new code.

However, for compatibility reasons, if the second parameter can be interpreted as a number between 0 and 3 it will be seen as the board_id parameter instead of the voltage value, to avoid breaking existing code. This does not change the behavior - the voltage is still applied to all boards - but allow legacy calls to keep working.

All of the examples on this page use the new format.

Examples

$ echo '{"command": "voltageset", "parameter":"yJN2nlj1,8.9"}' | nc $MINER_IP 4028 | jq
{
  "STATUS": [
    {
      "Code": 306,
      "Description": "LUXminer 0.1.0-15436f7140",
      "Msg": "Set Voltage",
      "STATUS": "S",
      "When": 1667917794
    }
  ],
  "VOLTAGE": [
    {
      "Board": 0,
      "Voltage": 8.899999618530273,
      "VoltageStep": 0.05
    }
  ],
  "id": 1

If the optional step parameter is provided, the value will be used instead of the normal ramping step. This can be used to quickly apply a configuration change, throwing safety over the window.

Do not use this option unless you know what you're doing; this can cause permanent damage to the rig/board, as well as a decrease in hashrate over time.

Use at your own risk.

In the example below, we change the step to 0.5 volts:

$ echo '{"command": "voltageset", "parameter":"yJN2nlj1,8.9,0.5"}' | nc $MINER_IP 4028 | jq
{
  "STATUS": [
    {
      "Code": 306,
      "Description": "LUXminer 0.1.0-15436f7140",
      "Msg": "Set Voltage",
      "STATUS": "S",
      "When": 1667917794
    }
  ],
  "VOLTAGE": [
    {
      "Board": 1,
      "Voltage": 8.899999618530273,
      "VoltageStep": 0.5
    }
  ],
  "id": 1

Parameters

Parameter	Notes
`session_id`	A valid session ID. See Session Management for details.
`board_id`	Deprecated. Board ID, starting from zero. Only for compatibility reasons; ignore this parameter when writing new code.
`voltage`	The desired voltage value.
`step`	Optional. The step size of the ramping. The default value is 0.05, and the max is 10.0.

Field details

Field	Notes
`Board`	Either the provided board ID, or zero. Only exists for compatibility reasons.
`Voltage`	The new voltage value.
`VoltageStep`	The step of the voltage ramp.

voltageset

voltageset

Description

Command

Examples

Parameters

Field details

On this page