S19 XP Xilinx

Requirements

1. Physical access to the miner.
2. 8GB Micro SD card.
3. The Xilinx flashing image.

Image Download

Download S19 Jpro Xilinx Image

Image Contents

s19xp-flash-card-7007.zip

This is the file you will need to extract and or copy the contents of to your Micro SD card. Use this file if you want to downgrade your Bitmain version to an older version. This is the file needed to allow Commander to install LuxOS if your original version is later than March 2024.

Steps to flash to an older Bitmain version.

1. Download the stock recovery image.
2. Format your 8GB Micro SD card (other sizes may work) to Fat32.
3. Extract and or copy the contents of the download onto your Micro SD card.
   • The contents of the image will consist of various files and folders. Ensure all files and folders are copied to the Micro SD card.
4. Remove the power cords from the miner. Allow it to fully stop, fans included.
5. Plug the Micro SD card into the Micro SD card slot on the control board.
6. Plug the power cables back into the miner.
7. The SD card will flash the NAND device on the control board. Once complete, the control board’s external LED will turn green. This flashing process takes less than one minute.

8. Remove the power cords from the miner. Allow it to fully stop, fans included.
9. Remove Micro SD card from the control board.
10. Plug in the miner power cables.
11. Wait for the miner to come back online by refreshing the web interface for the miner IP.
12. Once the miner is back online, no pools will be configured. Configure pools if desired.
13. Scan the IP address or range of IP addresses with Commander.
14. Install LuxOS with Commander.

15. If pools were not configured, once LuxOS is installed, configure the required pools.
16. Happy Hashing.